Looking for:
Bea bodyguard manual |
Bea bodyguard manual. Horton c4190 manual
User manuals - User manuals and advice for your devices - .
Page 4 of 12 LO21, MC15 , refer to the respective schematic for the module. Change IR frequency on one sensor. If in an application with high-gloss floors or multiple doors installed in vestibules, change to different frequency.
Page 8 of 12 Page 10 Row 1 spots 1 — 6 remain on even during the "closed-door" position. Page Troubleshooting Verify that there are no breaks anywhere in the wire harness. Print page 1 Print document 13 pages. Rename the bookmark. Delete bookmark? Cancel Delete. Delete from my manuals? Sign In OR. Don't have an account?
Sign up! Aside from placement on the header, the only mechanical adjustment that may be made to the sensor is the angle. The greater the angle, the farther from the door the pattern will be. It is recommended that for most applications, the unit be powered and walk tested at the pre-set.
After walk testing, if the detection field needs to be changed, then proceed with changes as explained next. To change the angle setting the end caps, lenses, center eye shield and terminal block if it has been wired must be. Once removed, release the white clips and rotate outward to remove the PCB. Once the PCB is completely. There are two clips per Bodyguard and the angle must.
The Bodyguard will flash a green LED at a rate of 2 Hz, then it will expire upon a successful set-up in the door closed position. NOTE: If applying the Bodyguard to a door control that requires a learn cycle upon powering, it is recommended to allow the doors to complete a. Activate the door to the full open position. Upon completion of the set-up for the door-open position, the doors will begin closing. Normal operation should. Proceed with fine-tuning to insure compliance with all current applicable safety standards i.
ANSI A If set-up is. Activate the door open and perform a door open set-up with the remote by pressing. Unlock, Magic Wand, 2. If the Bodyguard flashes green continue with final tune in.
If not, refer to Bodyguard User Guide. The most likely cause is the motor lead polarity is reversed at the lockout or data polarity is reversed at Bodyguard. In such cases, pattern location will have to be altered for proper placement of the. Try to avoid mounting locations that may pose potential problems such as directly over a door arm. Most double. Ensure compliance with current ANSI Change IR. Previous Page. Next Page.
Normal operation should resume thereafter. Page 2 9 Company Contact Do not leave problems unresolved. If a satisfactory solution cannot be achieved after troubleshooting a problem, please call BEA, Inc.
If you must wait for the following workday to call BEA. Never sacrifice the safe operation of the automatic door or gate for an incomplete solution.
No comments:
Post a Comment